News

Garage Vacuum Installation Planning Worksheet

Compare two garage vacuum locations using one endpoint Candidate A on the left and B on the right follow separate routes around the parked vehicle to the same cleaning endpoint E1. The schematic is not to scale and does not show hose reach.Two positions. One endpoint.Planning schematic / not to scaleParked carObstacleStorageABE1: same cleaning endpointRoute A: solidRoute B: dashedSurvey routes only. Not a hose-reach test.
Compare two positions using the same endpoint and parked-car layout. Illustration only: not to scale, not a hose-reach test.

Choose two possible positions, measure their routes to the same cleaning job, then check each against the exact model's manual. Your result may be a useful set of questions rather than an installation decision.

Open printable worksheet

1. Choose a Position

Park the vehicle normally. Label two survey positions A and B using repeatable wall references. Mark one exact cleaning endpoint E1 and use it for both routes. Record door, vehicle and storage positions. These are survey references, not drilling marks or recommended mounting heights.

Planning Record

Date / person: ____

Unit used throughout: ____

Exact model / variant, or Not selected: ____

Vehicle, door and storage positions: ____

Candidate A reference: ____

Candidate B reference: ____

Shared endpoint E1: ____

A visible wall, outlet or open area does not establish installation suitability.

2. Measure the Route

Record routes around obstacles, not a straight line through the car. Name turning points and measure each segment. Use one unit throughout. If a section is missing, mark the total incomplete.

Candidate A to E1

Position reference: ____

Obstacles and turning points: ____

Segment 1, start / end / length: ____

Segment 2, start / end / length: ____

Additional segments: ____

Total / unit / complete or incomplete: ____

Missing sections / next check: ____

Candidate B to the Same E1

Position reference: ____

Obstacles and turning points: ____

Segment 1, start / end / length: ____

Segment 2, start / end / length: ____

Additional segments: ____

Total / unit / complete or incomplete: ____

Missing sections / next check: ____

For another endpoint E2, copy both blocks. Date layout changes rather than mixing measurements from different conditions.

Filled Example: One Endpoint, Two Routes

Fictional measurements, not product specifications, recommended clearances or test results. The opening diagram is schematic, not a scaled drawing of these numbers.

  • Unit and layout: metres; car parked, doors closed, storage unchanged. Model: not selected.
  • E1: the same marked floor spot behind the parked car, shown below the car in the diagram.
  • A: left-wall reference. Down the left-side route to turning point P1 = 3.0 m; P1 to E1 = 2.0 m. Total = 5.0 m, complete.
  • B: right-wall reference. Down the right-side route to turning point Q1 = 2.5 m; Q1 to E1 = 2.0 m. Total = 4.5 m, complete.
  • Observation: B's recorded route is 0.5 m shorter. Neither position is approved; exact-model instructions are still missing.
  • Next action: obtain the correct manual and review both positions. Do not select B solely because its survey route is shorter.

A segment sum does not reproduce hose bends, connections, movement or usable reach, and does not establish cleaning performance.

3. Check the Manual

Use the exact model and variant. For each candidate, check mounting and fixings, footprint, doors and cabinets, electrical requirements, hose operation, and emptying/filter access. Write 'Not obtained' for missing instructions. Do not substitute another model's specifications, photographs or estimated clearances.

Manual Check: Copy for Each Candidate and Topic

Candidate / topic: ____

Observed fact or measurement: ____

Exact-model requirement, or Not obtained: ____

Manual title / revision / page / source URL: ____

Conflict or unanswered question: ____

Person responsible / evidence needed: ____

Next check / date: ____

Decide What to Investigate Next

Candidate to investigate: ____

Reason supported by the records: ____

Incomplete routes / unresolved conflicts: ____

Information needed / next action: ____

Owner / review date: ____

'Collect more information' is a valid outcome. This is an editorial planning template, not a manufacturer's manual or installation approval. It does not establish wall or electrical suitability, safe clearances, mounting methods or usable hose reach. Confirm current exact-model instructions and seek appropriately qualified advice where needed.

Still Choosing a Format?

Compare wall-mounted and portable

Affiliate disclosure: JC Shoppy may earn a commission from qualifying purchases through links elsewhere on this site, at no additional cost to you. This worksheet has no purchase link and reports no hands-on installation or hose-reach test.